burning time

英 [ˈbɜːnɪŋ taɪm] 美 [ˈbɜːrnɪŋ taɪm]

网络  燃烧时间

机械



双语例句

  1. The factors influencing IR decoy burning continuous time are determined by analyzing the circumstance and operating process of IR decoy.
    通过对红外诱饵使用环境及作用过程的分析,确定了影响红外诱饵所需燃烧持续时间的因素。
  2. Task revenue function is related to fire density, burning time and number of fire put out by robots, which is consistent with the realistic fire-fighting task model.
    收益函数与火势、燃烧时间和机器人扑灭火灾数有关,这切合实际救火模型。
  3. Waxes for Dropping Resistance from Candle's Container: Mainly used for candle dropping resistance from cup for cup candle to decrease the shrinkage of paraffin wax greatly and adding burning time of candle.
    杯蜡烛防脱杯剂:主要用于杯蜡制品的防脱杯处理,明显减少石蜡的收缩、加蜡烛的燃烧时间。
  4. If fuse is stored in such a way that it is damaged by moisture or in other ways, its burning time can change.
    导火线如贮存于潮湿的,或其它不利条件下,其燃烧速度会改变。
  5. The preparation conditions of fast sol gel process, the gelation initial temperature, the burning temperatures and the burning time were studied.
    研究了溶胶-凝胶制备过程的条件并提出凝胶化起始温度的控制问题,对降低煅烧温度和缩短煅烧时间也进行了实验。
  6. The relation equation of pressure drop in oil tank vers burning time and the air volume is established.
    导出了油箱容积、气箱容积、充气间隔的压力降和燃烧时间的关系。
  7. The results of 60L pressure tank show that the burning time and pressure of the gas generant can meet the requirements of safety airbag for vehicle.
    经60L压力舱试验表明:该气体发生剂具有合适的燃烧时间和燃烧压力,可以满足汽车安全气囊的要求。
  8. Burning time of metal particles in motor was calculated and analyzed by using empirical equation, and burning length of metal particles was estimated, which can provide reference for the design of chamber length.
    采用经验公式,对发动机中金属颗粒燃烧时间进行了计算分析,估算了金属颗粒燃烧长度,为燃烧室长度设计提供了依据。
  9. According to the burning time, author set up the mathematics model of the coal burning rate. The decomposing rate of carbonate lies on balance principle of quality and energy.
    以燃尽时间为基本参数建立了分解炉内煤粉燃尽率的数学模型,并根据质量平衡和能量平衡原理,确定系统平衡关系,获得碳酸钙分解率的数学模型。
  10. The computer aided analysis ( CAA) and computer aided drawing ( CAD) tech-nique is applied to determine the burning time t_b of a micro solid rocket motor.
    应用计算机辅助分析(CAA)与计算机辅助绘图(CAD)方法,确定微型固体火箭发动机燃烧时间tb。
  11. We classified the heavy metals according to its features and occurrence, and studied the effect that the burning temperature, burning atmosphere and burning time impacted on the volatilization of heavy metals.
    考察燃煤重金属元素的挥发析出特性:根据重金属元素的自身特性和赋存状态,对重金属进行了有机分类:并且研究了燃烧温度、燃烧气氛、燃烧时间等因素对重金属挥发性的影响。
  12. The development of ignition technology on the internal combustion engine is outlined in this paper. The ignition energy, efficiency, burning time and main chemical reactions of the pulsed corona discharge ignition ( PCD) used on internal combustion engine are discussed in detail.
    介绍了内燃机点火技术的研究进展,阐述了内燃机脉冲电晕放电点火新技术所涉及的点火能量、点火效率、燃烧时间和相关化学反应等问题。
  13. Based on the results of tests, the relationship between burning rate augmentation and burning time is discussed. A physical model is also presented and studied.
    根据试验结果,论述了燃速增加率与燃烧历程的关系,提出和探讨了燃烧物理模型问题。
  14. Based on the diffusion control model and reaction kinetics control model, the burning out time of volatile is calculated respectively.
    在扩散控制、动力控制条件下,分别对蔗糠挥发分燃烬时间进行了计算。
  15. This paper elucidates the relationship among the MgO's burning temperature, burning time with MgO's rate of hydration, rate of swelling, and swelling capacity.
    本文阐述了氧化镁(MgO)的煅烧温度、煅烧时间与MgO产生的水化速率、膨胀速率和膨胀量等之间的关系。
  16. That is, ( 1) Effects of difference of celluloses on burning time;
    具体有以下4方面的措施:(1)纤维素种类对于燃烧时间的影响;
  17. While burning power density is weak, hole depth will be exponentially dependent on burning time.
    弱场下,孔深与烧孔时间成指数关系。
  18. A mathematical model to represent combustion of single pulverized coal particle has been developed. The model is used for predicting the burning rate, burning time, burning temperature in different conditions for different coal particle size.
    建立了单颗粒煤粉燃烧数学模型,并模拟了不同条件(不同煤粉直径、不同环境温度及氧浓度)下煤粉的燃烧过程。
  19. Discuss on the Relation Between the Burning Time and the Formulation of Boron Type Delay Composition
    硼系延期药燃烧时间与配比的关系探讨
  20. This paper also studied effects of categories of semi-coke, total pressure, oxygen concentration, particle size and heating rate on maximum mass loss-rate, burning time, burn-out temperature, and described the dynamic transformation of combustion reactivity of semi-coke under different testing condition.
    分析了半焦种类、实验总压、氧浓度、试样粒径和加热速率对最大失重速率、最大失重峰温、燃烧时间、燃烬温度等的影响。
  21. Compared with pulverized coal, waste plastic has lower ignition temperature, lower rapid ignition temperature, shorter burning time, higher burning rate and lower ash ratio after burning, which is beneficial to BF injection.
    废塑料的开始燃烧温度和激烈燃烧温度都比煤粉低,燃烧时间较煤粉短,燃烧速度快,燃烧灰烬少,因此更有利于高炉喷吹。
  22. The relative completed burning time was short, and the completed burning rate were high.
    相对燃尽时间较短,燃尽率较高;
  23. CAA and CAD Technique for Determining Burning Time of a Micro Solid Rocket Motor
    确定微型固体火箭发动机燃烧时间的CAA与CAD技术
  24. A Research of Factors Affecting the Burning Time of Safety Fuse
    导火索燃烧时间影响因素的探讨
  25. The results of research indicate that the pressure, the thrust and the fuel regression rate of the motor decrease while the O/ F ratio increasing with the burning time lasting. The special impulse reduces when throttling.
    研究结果表明:压强、推力和燃料退移速率随发动机工作时间增加而降低,氧化剂和燃料的配比升高;节流时,发动机比冲降低。
  26. Burning time increases with the oxygen concentration.
    燃烧时间均随氧气浓度增加而减少。
  27. Based on the digital image processing on the photos, it gains some of the arc macroscopic parameters such as root radius, column radius, length, burning time, and so on.
    根据拍摄的照片进行数字图象处理,得到电弧的一些宏观参数如弧根半径、弧柱半径、弧长、燃弧时间等。
  28. Adding pulping waste liquor could lower the ignition temperatuer, but increased the burning time. It had no influence on the ash content of the briquettes.
    掺加造纸废液后,成型燃料易着火,但燃烧时间较长,不会增加成型燃料的灰分。
  29. With the increase of the amount of mercaptan, the Mooney viscosity and several average molecular weight were decreased, but had no significant effect on the burning time.
    随着硫醇用量的增加,橡胶的门尼粘度和数均分子量都成降低趋势,但对焦烧时间无明显影响。
  30. Besides, whether resources are adequate and whether it is need to schedule resources in advance is determined by comparing the fire burning time and the time of the existing resources can be used.
    通过比较预测的火灾可能燃烧时间与现有资源能够坚持的时间,判断资源是否够用,是否需要提前调度资源。